Through Hole Rework Station

The equipment adopts the spray tin liquid directly on the solder joint of the through hole component to desolder or solder.

PCB dimension: W400×D400mm

PCB locating way: Jig

Power supply: single-phase 220v, 50/60Hz

Heater: 2000W

Tin volume capacity: 30kgs

Machine dimension: L600×W600×H240

Weight: Appox. 40kgs

------------------------------------------------------------------------------------------------------------------------------

 Through hole rework station;

* The equipment adopts the spray tin liquid directly on the solder joint of the through hole

  component to desolder or solder;

* A wide large range up to 180 mm of disassemble parts. Install/solder the components in 5

  seconds;

* The splint device is easy to operate and can splint the PCB sheet in a large spectrum;

* The upper and lower nozzles are configured to the corresponding component size and align 

  centre by the upper nozzle;

* It has global and accurate alignment, PCB board can be adjusted to X/Y directions by

  accurate alignment;

* Pedal switch controls the solder wave switch, the speed adjusted knob can adjust the 

  solder wave height continuously. Solder wave time can be set, PCB board and parts are

  kept far from harm;

* The equipment has temperature protection. When the solder temperature doesn't reach the

  set one, the solder wave doesn't work. This work temperature can be set according to

  different conditions with alarm ring and indication light;

* Less solder oxide.

Through Hole Rework Station